The Biansi eGo-T (Tank) system is made up of three primary components as illustrated
in the photo above.

The Battery is a lithium ion battery. When you first get your kit you should charge
your batteries completely. It will take approximately 2 hours to fully charge your
batteries.

Your batteries are equipped with a 5-click off/off feature. Press the button 5
times quickly within 2 seconds, your battery tip will flash, it will now be off.
Press it again 5 times again to turn it back on. The batteries usually ship in the
off position.

 

The Atomizer heats the liquid contained in the cartridge to produce the vapour.
When you first get your atomizer you will have to prime it. If you look into the
top of the atomizer, you will see a post. One or two drops of liquid on the post
will suffice. It is very important to not let your atomizer run dry. Running it dry
will burn out your atomizer. When inserting the Cartridge into the atomizer, the
post must penetrate the hole in the bottom of the cartridge.

 

 

The Cartridge is where you put your choice of vapour liquid. The Cartridge will
hold approximately 1.1ml of liquid. To fill the cartridge, you "can" remove the
silicone cap on the end of the cartridge and drip liquid directly into the chamber
but we recommend using a needle tip bottle to prevent damaging the end cap.
Continue filling the cartridge until the chamber is approximately 3/4 full.

 

The Charger cable can be plugged into a USB port on your computer or into a
USB wall adapter that plugs into your household outlet. When connecting the
battery to the charger it should be snug but do not over tighten. When you feel it
stop that is good. The light on the charger will turn red and remain red while it is
charging your battery. Once fully charged it will turn green. Charging generally
takes about 1.5-2.5 hours on the wall charger but could take longer when
connected to computer or other USB port. These batteries do not have a
memory and will not overcharge. They can be left on the charger overnight
without concern.

Care and Maintenance - This is an electronic device; do not use water to clean
any of the electrical connectors. Every day, clean the atomizer threading, the
battery threading and the inside threading on the charger with a piece of dry
paper towel. Keep all components out of the reach of children, and pets.